Attaching the motor to the motor adapter

  1. Clean the motor shaft and flange surfaces of the motor and the motor adapter. These must be dry and free of grease!
  2. To avoid contact corrosion, apply some assembly paste, for example NOCO®-Paste to the motor shaft.
  3. Push the coupling half onto the motor shaft and position it. When doing this, observe the information in chapter Claw coupling and the figure below. The coupling size and the type are noted on the coupling.

    4. [1]

    Motor adapter

    XA

    Distance of the coupling to the flange surface of the motor adapter

    E

    Mounting dimension

    XM

    Distance of the coupling to the flange surface of the motor

    → XM = XA - E

  4. Secure the coupling half using the set screw.
  5. Mount the motor onto the motor adapter, making sure that the claws of the coupling engage each other.