Procedure
Check that the following conditions have been met:
- Connect the pressure switch [2] to the operator's control. Observe chapter Pressure switch.
- Fill the gear unit with the oil type and oil quantity corresponding to the nameplate data. Check the oil level. For further information, refer to chapter Changing the oil.
- Immediately before initial startup, open the screw plug [3] and fill the shaft end pump [1] completely with oil. After having filled in the oil, close the screw plug [3].
- This procedure must be repeated after a downtime of more than 6 months or an oil change.
- Before startup, fill the additional mount-on components (such as piping, cooler matrix, etc.) with oil on the pressure side. Doing so ensures that there is a sufficient oil supply when the entire system is started up. The oil filling holes are marked in the order dimension sheet.
- For further information, refer to chapter Startup.
Additional information
