Positioning the thermostat

Depending on the installation situation of the drive, it might be necessary to change the position of the thermostat.

To position the thermostat, proceed as follows:

  1. Loosen the clamping screws [2].
  2. NOTICE! Ensure that the cable gland is properly positioned during installation. Possible damage to property. Mount it in such a way that no moisture can enter. Turn the thermostat to the required position.
  3. Tighten the clamping screws [2] again.

    4. [1]

    Threaded jacket

    [2]

    Clamping screw

    [3]

    Thermostat

    [4]

    Cable gland

The screw-in sleeve [1] prevents oil from escaping. The sensor of the thermostat is located in the threaded jacket [1] and held in place by 2 clamping screws [2]. Observe the additional manufacturer's documentation.