Absolute positioning

Parameter name

Description

Absolute positioning

Without referenced encoder
  • Yes – Allow positioning if the inverter has not yet been referenced.
  • No – Do not allow positioning if the inverter has not yet been referenced.

Index: 50003.1

IEC name: ProfileGeneration.Positioning.Config.xWithoutReferencedEncoder

Target position monitoring
  • On – Check whether the target position is within the set software limit switches. If the target position is outside the set software limit switches, the motion is not started and an error is displayed.
  • Off – Do not check if the target position is within the set software limit switches.

Index: 50003.2

IEC name: ProfileGeneration.Positioning.Config.xTargetPositionMonitoring