Installing EH7., AH7.

  1. Push the encoder to the stop of the shaft end.
  2. Tighten the screw [B].
    • Tightening torque 3 Nm
  3. Proceed as follows, depending on the encoder:
    • EH7.: Install the nut [734].
    • Tightening torque 3 Nm
    • AH7.: Insert and tighten the screw [748].
    • Tightening torque 12 Nm
  4. Mount the cover plate [657] using the screws [659]/[1711].
    • Tightening torque 11 Nm