Setting up the fieldbus connection

Perform the following steps to give the MOVI-C® CONTROLLER access to the fieldbus via IEC function blocks. These settings are required for direct fieldbus connection of software modules.

  • A MOVISUITE® project has been created and is open.
  • The MOVISUITE® project includes a MOVI-C® CONTROLLER.
  1. Open the configuration of the MOVI‑C® CONTROLLER.
  2. In the "MOVIRUN® flexible" section, open the "Module configuration" > "Fieldbus interface" configuration menu.
  3. Select the fieldbus protocol in use in the "Fieldbus card" section.
  4. In the "Fieldbus connection via IEC function blocks" section, set the "Activate fieldbus connection" option to "Yes".
  • The fieldbus connection has been set up successfully.