Print mark controller

Print mark controller

Proportional factor

The proportional factor is used to set the level of the proportional phase correction, which is performed by the print mark controller. If the proportional factor is greater than 0, the "Print mark controller" function performs a phase correction to control the print mark position.

The output of the proportional correction is limited relative to half of the set cut length.

Index: 50040.60

IEC name: -

Integrative factor

The integrative factor is used to set the level of the integrative cut length correction, which is performed by the print mark controller. If the integrative factor is greater than 0, the print mark controller corrects the cut length.

The output of the integrative correction is limited relative to set cut length.

Index: 50040.61

IEC name: -