Simple positioning application module

The simple positioning application module is suited for many applications that have so far been implemented by switching between rapid and creep speed.

Compared to conventional encoders, a cost-effective EI7C built-in encoder with up to 24 pulses per motor revolution is used, see the following figure. An encoder card is no longer necessary because the simple encoder can be directly connected to the MOVITRAC^® B inverter. Another advantage is the compact design that makes it possible to integrate the encoder into the motor without adding extra length.

The parameters are set with the IPOS^® positioning control by means of the MOVITOOLS^® MotionStudio engineering software.

Built-in encoder EI7C

For detailed information, see chapter “Built-in encoder connection”.