Return codes (r19 – r38)

Return codes when entering / editing a unit parameter in the FBG11B:

No.	Designation	Meaning
	Only read access	Parameter cannot be changed
19	Parameter lock activated	Parameters cannot be changed
	Factory setting in progress	Parameters cannot be changed
	Option card missing	The option card required for the function is missing.
	Option card missing	The option card required for the function is missing.
	Controller inhibit required	Controller inhibit required
	Invalid value for parameter.	Invalid value for parameter. FGB manual operation selection invalid as PC is in active manual operation.
	Enabled	You cannot perform this function in ENABLED status
	Error in sequence	Error while saving in FBG11B. Startup not performed with FBG. Perform startup with MotionStudio or select a new motor.
	FBG11B incorrect data set	Stored data set does not match the unit