Supported G-functions
Additional information
- G0 – Point control behavior (PTP)
- G1 – Linear interpolation
- G2 – Clockwise circular interpolation
- G3 – Counterclockwise circular interpolation
- G4 – Dwell time in seconds
- G9 – Exact stop (deactivate blending) in sets
- G17 – Plane selection X-Y
- G18 – Plane selection Z-X
- G19 – Plane selection Y-Z
- G53 – Selection of machine coordinate system (base coordinate system) / modal disabling of programmed shifts
- G54 – Selection of workpiece coordinate system selection (user coordinate system) / modal enabling of programmed shifts
- G60 – Modal activation of exact stop (deactivate blending)
- G64 – Modal deactivation of exact stop (activate blending)
- G71 – Dimensions in millimeters
- G90 – Absolute dimensions (absolute positioning)
- G91 – Incremental dimensions (relative positioning)
