Startup procedure

Perform startup of the devices using the MOVISUITE® engineering software of SEW‑EURODRIVE.

The startup procedure is divided into segments. The following steps illustrate an example of the startup procedure for an device.

Drive train segment

Drive train

Configuring drive trains.

Interfaces segment

Standard interfaces

Basic settings of the standard interfaces

  • Fieldbus
  • Standard I/O
  • Encoder 1

Functions segment

MOVIKIT® configuration

 

  • Basic settings
  • Monitoring functions
  • Drive functions
  • Inputs/outputs
  • Process data interface

PO configuration

  • Advanced PO configuration

PI configuration

  • Advanced PI configuration

Drive functions

  • FCB 05 Speed control
  • FCB 06 Interpolated speed control
  • FCB 09 Positioning
  • FCB 10 Interpolated position control
  • FCB 12 Reference travel

Advanced
drive functions

  • FCB 01 Output stage inhibit
  • FCB 02 Stop default
  • FCB 20 Jog mode
  • FCB 21 Brake test
  • FCB 26 Stop at user limit

Event-driven functions

  • Touchprobe 1
  • Cam switch

Monitoring functions

  • Reference signals
  • Limit values 1
  • Monitoring functions 1
  • Energy-saving function

User units

Converting system units into user units.

Information on the drive unit

Device data is available via the project node.

Device data

  • Device identification
  • Main component
  • Subcomponent
  • Production label

Setup

  • Access rights
  • Resetting device parameters.
Additional information