Installing shield connection plates

  • Required material: Accessories SCM-Z-002, part number: 28284097
  1. Attach the signal shield connection plate to the signal side of the device (top) with 2 x M4 screws. Tighten the M4 screws with a tightening torque of 3 – 3.4 Nm.
  2. Attach the power shield connection plate to the power side of the device (bottom) with 2 x M4 screws. Tighten the M4 screws with a tightening torque of 3 – 3.4 Nm.
  3. Use the cable ties as strain relief.

[1]

Signal shield connection plate

[3]

Power shield connection plate

[2]

M4 screws (2 ×)

[4]

M4 screws (2 ×)