Work steps with electronics cover size 1

NOTICE

Loss of the guaranteed degree of protection.
Damage to property.
  • When the cover is removed from the connection box, the cover and the wiring space must be protected from humidity, dust or foreign particles.

Replace the seal of MOVIMOT® advanced as follows:

  1. Perform the steps described in the Preliminary work regarding inspection and maintenance chapter.
  2. Loosen the screws from the electronics cover and remove them.
  3. NOTICE! Loss of the guaranteed degree of protection. Damage to property. Make sure not to damage the sealing surfaces when removing the gasket. Loosen the used gasket by levering it off the retaining cams.
    • Doing so will be easier if you adhere to the sequence shown in the figure below.
  4. Remove the old gasket completely from the connection box.
  5. CAUTION! Risk of injury due to sharp edges. Cutting injuries. Use protective gloves when cleaning. Ensure that work is carried out by trained specialists only. Carefully clean the sealing surfaces of the connection box and electronics cover.
  6. Place the new gasket on the connection box and fix it with the retaining cams. Installation is facilitated if you follow the illustrated order.
  7. Check the installation and startup of the unit using the corresponding, applicable operating instructions.
  8. Place the electronics cover back onto the connection box and secure it.
    • Pay attention to the following procedure when screwing on the electronics cover: Insert/screw in the screws and tighten them in diametrically opposite sequence step by step with a tightening torque of 6.0 Nm.