Steps

NOTICE

Loss of the guaranteed degree of protection.
Damage to property.
  • When the cover is removed from the connection box, the cover and the wiring space must be protected from humidity, dust or foreign particles.

Replace the gasket of the MOVIGEAR® performance as follows:

  1. Perform the steps described in the chapter Preliminary work for inspection and maintenance.
  2. Loosen the screws of the electronics cover and remove it.
  3. NOTICE! Loss of the guaranteed degree of protection. Damage to property. Make sure that the sealing surfaces are not damaged when removing the gasket . Loosen the used gasket by levering it off the retaining cams.
    • Disassembly is easier if you adhere to the sequence shown in the following figure.
  4. Remove the old gasket completely from the connection box.
  5. CAUTION! Risk of injury due to sharp edges. Cutting injuries. Use protective gloves when cleaning. Ensure that work is carried out by trained specialists only. Carefully clean the sealing surfaces of the connection box and the electronics cover.
  6. Place the new gasket on the connection box and fix it with the retaining cams. Installation is facilitated if you follow the illustrated order.
  7. Check the installation and startup of the drive unit based on the applicable operating instructions.
  8. Place the electronics cover back onto the connection box and secure it.
    • Pay attention to the following procedure when screwing on the MOVIGEAR® electronics cover: Insert/screw in the screws and tighten them step by step in diametrically opposite sequence with a tightening torque of 6.0 Nm.