Connection box and electronics cover (internal) size 1
The following figure shows the connection box and the bottom side of the electronics cover:
[1] | Cable glands |
[2] | Connection box |
[3] | Line connection L1, L2, L3 |
[4] | Braking resistor connection |
[5] | Plug connector connection unit for electronics cover |
[6] | Electronics terminal strip |
[7] | Fieldbus connection (depends on the configured connections) |
[8] | Engineering interface |
[9] | Electronics cover |
[10] | DIP switches S1/1 – S1/4 |
[11] | DIP switches S2/1 – S2/4 |
[12] | Replaceable memory module with S3 DIP switch |
[13] | Inner electronics cover nameplate |
[14] | Screws for PE connection |
[15] | Shield clampUse the shield clamp included in the accessory bag that contains installation equipment. |
