Creating a project

INFORMATION

For detailed information on how to use the MOVISUITE® engineering software, refer to the corresponding documentation.
  • A new MOVISUITE® project has been created and is open.
  1. Add the required device nodes and software modules to the project.
    • See "Adding a software module" and "Example project" as well as the documentation for the devices and software modules used.
  2. Configure the added devices or software modules.
    • Observe the configuration explanations specific to theMOVIKIT® RotaryKnife in this manual.
    • For detailed information on configuring the devices used or the software modules used in this project, refer to the corresponding documentation.
Additional information