Connector status
The following driver settings must be set both for the master and for all slaves of the network:
Connector Status PLC in stop | |
|---|---|
MOVI-C CONTROLLER LAN2 * | ModuleWorking |
EtherCAT® | ModuleEnabled, DriveFound, ModuleFound, ModuleConfigured |
Connector Status PLC in run | |
|---|---|
MOVI-C CONTROLLER LAN2 * | ModuleWorking |
EtherCAT® | ModuleWorking |
* Is only displayed for the master. | |
You find the settings for the master and the slaves under the [Status] menu item.
If the driver settings differ, you have to adjust the project to the current firmware of the MOVI‑C® CONTROLLER. For more information, refer to the MOVISUITE® manual.
The log file of the MOVI‑C® CONTROLLER provides more detailed information.
