PROFIsafe fieldbus operation

If you want to use fieldbus operation and "PROFIsafe", make the following setting in the Assist CS.. tool: In the "F‑protocol" under "Configuration", set the "F‑protocol type slave slot" to "PROFIsafe". Then also specify the "PROFIsafe slave F-address" in the "PROFIsafe" section.

Take the CS.. safety option into operation and download the values into the axis. Generate the acceptance report using the Assist CS.. tool and carry out an acceptance of the parameter setting of the safety option.

INFORMATION

For a test run, the IEC project can be created without generating a report and without validation.